Modules & Connecting Blocks
78944PSRP
One Zone Connecting Block with Power Supply
- Connects four emitter ports and power supply to all Xantech infrared receivers and keypads.
- Four parallel emitter ports with 470 Ohm resistors drive 4 single or 4 dual emitters.
- Quick-connect stereo mini jack for Xantech IR Receivers that use a stereo mini plug.
- STATUS terminal for connection of Xantech IR Receivers and Keypads that have status indicator LED's.
- 2.1 mm coaxial power jack.
- Uses either the 781RG or 782-00 power supply.
- Dimensions: 3" x 1 3/4" x 13/16" (77mm x 45mm x 21mm)
- 781RG power supply is included.
79000
Multiple Emitter Connecting Block
FEATURES
- Emitter expansion block for the 791-44 or 792-10.
- Parallel emitter ports drive 10 single or 10 dual emitters.
- Contains a series 100-ohm resistor per emitter port.
- Emitter & IN/OUT ports are 3.5 mm mono mini jacks.
- Screw terminals provide for wired input connections.
- Requires the 792-10 Power Module or the 791-44 Amplified Connecting Block to drive the 790 block
- Dimensions: 6" x 2 1/4" x 15/16" (153mm x 58mm x 24mm)
79144
One Zone Amplified Connecting Block
- Amplified version of the 790-00.
- Emitter ports with jumpers permit high or low power
- High-speed opto-isolator for improved operation.
- Quick connect stereo mini jack for Xantech IR Receivers that use a stereo mini plug.
- Parallel emitter ports drive 10 single or 10 dual emitters.
- Up to nine 790-00's can be connected to the 791-44 if more than 10 emitter ports are needed
- STATUS terminal for connection of Xantech IR Receivers and Keypads that have status indicator LED's.
- Contains red LED input signal Test-IR
- Uses either the 781RG or 782-00 power supply.
- Dimensions: 6" x 2 1/4" x 15/16" (153mm x 58mm x 24mm)
79620
Six Zone Connecting Block / Expander
- Expands the 795 Zone Controller to a total of 9 zones.
- Connects directly to the 795 and is powered via the 795.
- Can be used in conjunction with a 791-44 (without a 795) for a 6 zone system.
- Multiple 796's may be used with a 791-44 for even more zones (limited only by IR noise considerations).
- Dimensions: 1" x 13 3/8" x 1 7/8" (26mm x 340mm x 48mm)
CB12
One Zone Connecting Block
- Connects one emitter port and power supply to Xantech IR Receivers that use a stereo mini plug.
- Also includes a 3-terminal block for wired connection of Xantech IR Receivers and Smart Pads.
- 3.5 mm stereo mini jack for quick-connect IR receivers.
- 3.5 mm mono mini jack for 1 single or 1 dual emitter.
- 2.1 mm coaxial power jack
- Uses either the 781RG or 782-00 power supply.
- Dimensions: 2-1/8" x 1-1/4" x 3/4" (54mm x 32mm x 19mm)
